
page 25
If you would like confirmation that your SMS command has been successfully received by
the G-SPEAK, simply append a space and then the letters ‘ACK’ to the end of the
command set in the SMS message. For example: P.xxxx.AB.0821234567 will simply
add phone number 082 123 4567 and assigns it to Button 1; however,
P.xxxx.AB.0821234567 ACK will do the same but you will also receive an SMS
back from the G-SPEAK that reads ‘AB OK’ confirming that the Add Button command
has been successfully executed.
Command ‘AB’
As described in the Voice Phone Functionality section, a Voice Phone will be called when
either of the two Call Buttons are pressed and is able to activate the outputs by pressing
1, 2, 3 or 4 on the phone keypad. This command set essentially assigns a phone number
to a Call Button.
Description Parameters
Adds a new Voice Phone number
to be called when a specific Call
Button is pressed
Phone number(s) (up to 16
digits each)
Call Button BU (1 or 2)
N – Subscribe to System
Notifications
AB
(commands have been highlighted for clarity)
Adds phone number 082 123 4567 and
assigns to Button 1. Does NOT add phone to
Switch Phone database.
Examples
Command
Description
P.xxxx.AB.0821234567.BU1
P.xxxx.AB.0821234568.BU1.2.N
Adds phone number 082 123 4568 and
assigns it to Button 1 as the second number to
be called. System Notifications will be sent to
this Voice number. (Classic+ only). Does NOT
add phone to Switch Phone database.
Adding a New Voice Phone to a Call Button
SMS Command Confirmation
Audible Command Confirmation
The Calling Module will also provide audible feedback and confirmation of commands
received:
One beep if the command is accepted and valid
Two beeps if a syntax error is present
Three beeps if the command is sent from a number that is not a Voice number or
if the command is sent with an incorrect password
Komentáře k této Příručce